Top level regardless of vehicle maintenance costs, as long as the car is bought, it is necessary and timely maintenance of the vehicle. Even the usual "reluctant" to drive, do not start due to the long, maintenance does not decrease the cost will increase. So, you want to travel unhindered their car, still have regular car maintenance.
According Hengding automobile hub unit is understood that when the wheel surface stains difficult to remove when you want to use professional cleaning agent, which can often mild cleaning agents effectively remove stains, reduce the aluminum surface damage. In addition, the hub itself there with a layer of metal protective film, so pay special attention when cleaning Do not use paint brightener or other abrasive materials. Be careful in driving the process, to avoid virtually scratch wheels caused by the "flawed", once you have scratches or deformation, it should be repaired as soon as possible and its re-paint treatment.
With scratches how to fix?
There are specific steps to repair six steps:
First, check the wounds, as no injury to the inside of the hub, you can simply repaired using paint diluent, wipe the scars around to remove dirt;
The second step, the deepest part of the scratch is difficult to remove dirt, then it can be used toothpicks thoroughly cleansed;
The third step: To prevent mistakenly irrelevant by painting the tape carefully affixed best around scars;
The fourth step, tidy hair tip, coated with modified paint, shrink slightly after drying paint, protruding slightly smeared some of the best;
The fifth step, after the painting, to be completely dry probably need a week's time. After drying, the paper dipped in soapy water coating, smoothing the surface;
The sixth step, water-resistant paper with post-grazed, struck a light with mixture, then whisk waxing.
If you encounter deep wounds, the focus is to observe whether the exposed metal surface, if not invisible metal surface rust, you can concentrate on modifying painted lacquer. Place the pen tip up a little bit, and then wait for the paint to dry completely. And to avoid this phenomenon, the car used in the beginning must be diligent flushing rim, a day of driving the vehicle at least once a week to wash the rim, washed with water after the first wet, then scrub sponge cleaner and then flush with water.
Routine maintenance can not be ignored
Routine maintenance is also essential when high temperatures hub, should be allowed to cool before cleaning, do not use cold water to wash; otherwise damaged alloy wheels make even the brake disc deformation affect the braking effect. In addition, at high temperatures with detergent to clean aluminum alloy wheels sets, make hub surface chemical reactions, loss of luster, affect the appearance.
When stained difficult to remove asphalt on wheels, to no avail if the general cleaning agents that can be used to try to clear brush, but do not use strong brush, especially iron brush, so as not to damage the hub surface. Some experts have introduced a clear asphalt recipe: the selection of medicinal "active oil" rubbed, get unexpected results, the owner may wish to try.
According Hengding automobile hub unit noted, in extremely clean conditions for assembly, parts work surface without knocking, no scratches, burrs and other attachments; strict rules, seals should be properly installed, do not be in place to prevent deformation; grasp Performance specifications and requirements of the seal, the timely replacement of failed parts; side cover classes for thin-walled parts, the use of sheet metal cold do correction; easily worn shaft hole parts can be metallized, repair welding, gluing, machining and other processes in order to achieve the original size; make use of sealants, paints alternative available when necessary to achieve the desired sealing effect; nut off the slide wire buckle, loose should be repaired or replaced with new parts and tighten to the required torque; rubber seal assembly should be carefully examined before the appearance of quality; pressure with the use of specialized tools, to avoid banging deformation; filling grease required regular cleaning to clear the air vent and a one-way valve. As long as the above, the vehicle is completely wrong oil spill cure.
