The so-called automotive beauty means to maintain and restore the technical performance of the car, to ensure that the car has good usability and reliability. It contains a lot of knowledge, timely and correct maintenance will extend the life of the car's safety performance improved, both to save money and eliminates many repair troubles. However, nowadays the "repair on behalf of Paul," the driver of the team concept still exists, due to lack of insurance or accident caused by improper maintenance around. Therefore, timely and proper vehicle maintenance is to extend the life of the car, to ensure traffic safety an important part. According Hengding automobile hub unit unit pavers understand what role:
According Hengding automobile hub unit is understood paver is a major highway construction equipment for base and surface layers of various materials paving job. There are a variety of different systems complement each other to complete the paving work consists mainly of walking systems, hydraulic systems, transmission of material systems. In order to improve the life and reduce the incidence of mechanical failure, should do maintenance work. Here are some common sense care Xiaobian summary, we want to help.
1 out of every 250 hours required to replace the oil filter, lubricate the new engine for the first time replacement should be performed after 50 hours. Fuel filter should replace the filter every 250 hours of work.
2, such as the discovery engine exhaust smoke or decrease the output power required for air filter cartridge be purged.
3, when the filter was purged three times or fouling too much, it should be replaced with new products. (Note that purge, the air pressure should not exceed 5 bar, and an air nozzle at an angle to the filter should Cotton team).
4, check the filter for damage, can be a light bulb into the filter, the light can be observed by penetrating damage.
5, not once a fortnight to check the battery level, when necessary, add more distilled water.
6, the dust discharge valve requires emissions once every two weeks.
7, for when the battery charge, then unplug the power plug to the electronic components, the first pick when the positive terminal connection, connect the negative terminal.
8, hydraulic oil replacement should be made after the initial work 125 hours and 2,000 hours, then after every 2000 hours of replacement, but should be replaced at least once a year. Hydraulic oil filter change along with the replacement.
9, the hydraulic system return line filtration and ventilation filters every 500 hours into gasoline to clean, dry installation.
10, on the V-belt tension checked the engine (with the thumb pressed between two pulleys, whether hanging from the slack exceeds 10-15mm) for the new machine was eight days after the inspection, and then inspected once every four weeks.
11 things to slide parts and shaft-type parts must be lubricated with grease commonly used multipurpose lithium grease.
12, for the paver drive chain should be lubricated once a week, using a similar high quality oil sae oil viscosity under normal operating conditions.
13, once a month using a solvent to clean the drive chain, and be lubricated.
14, when laying asphalt paver, every day after the end of the operation should be in the machinery is still in the working conditions of temperature and turning the screw on the cantilever material handling equipment and auger until grease lubrication carried out so far.
15, screw driver inside the center of the bearing is continuous oil lubrication oil needs to be replaced, but to supplement regular basis to exclude dirt and oil inside.
16, with the drive gear box should be checked weekly gearbox oil leakage, every two weeks to check the gearbox oil level should be maintained between the highest and lowest. Initial work 500 hours and 2000 hours of work each subsequent replacement or replaced once a year to be replaced after 2000 hours of lubricants.
